Semi-Outdoor Clay Plaster-Coarse

Actual colour and texture will be related to actual light. Colour deviations cannot be excluded, each batch of product and aggregate accumulations may cause colour to vary slightly (It’s recommended to order amount required in one purchase). 實際色彩質感與光線有關。無法排除顏色所呈現色差，每一批產品和刷塗堆疊次數都會導致顏色略有差別（建議一次採購所需的量）。

• Natural Mineral Colour / 礦物原色

• Improve Air Quality / 淨化空氣

• Regulate Humidity / 調節濕度

• No Fading Problem / 永不褪色

• Low Environmental Impact / 環境友善

Description: It is designed for trowel application with a distinct textured finish. Semi-Outdoor Clay Plaster include 5% of acrylic polymer to address outdoor climate conditions. Therefore, it is less breathable but offers better abrasion resistance and water resistance compared to our other clay series products and cannot rehydrated and reused once actual dry. For best results, it should be applied on a rough substrate (such as a cement-painted surface or apply mineral primer as a base coat if necessary). 描述 | 鏝抹以製造明顯獨特紋理的飾面；半戶外設計款 添加了5%的丙烯酸聚合物以應對戶外氣候條件，因此相對耐磨，耐水性佳，適合表塗，調濕效果一般，用於乾區；一旦完全乾燥，便無法重新使用。基材要求粗糙（例如水泥漆面，若有需要請使用市面上的礦物底漆進行打底）。

Application: Apply 1 coat is enough (about 1mm thick). For interior and semi-outdoor use, do not continue splashed by water. It is always recommended to try it on a small area first! 應用 | 塗抹1層（約1mm厚）即可。適用室內和半戶外空間，水不易持續潑灑處。永遠建議先小面積試做！

Types: Coarse particle sizes (0-1.3mm), matte and rough surface. 款式 | 粗顆粒（0-1.3mm），啞光粗糙面。

Storage: Keep in a dry and cool place. 保存 | 保存於陰涼處。

Installation Steps:

1. Check and prepare the subsurface in good condition (rough and clean). 診斷和確保施做基材狀況良好（應夠粗糙且乾淨）。

2. Pour out the precipitated water and stir Semi-Outdoor Clay Plaster thoroughly by using mixing drill (continue for about 10 minutes). 倒出沉澱水分並用打泥器均勻攪拌（約連續十分鐘）。

3. Apply 1-2 coats by flexible trowel in a thin coat. Allow each coat to dry (about 1 day) before the next coat is applied. Install Mineral Primer if necessary before applying clay plaster to get a slightly rough surface so that it can adhere well to the substrate. 使用鏝刀（軟推刀）塗抹1～2層塗料，在塗抹新的一層時，請確保上一層已乾燥（約1天）。若有需要，請事先使用礦物底漆進行打底以便能使泥土塗料更好的附著在基材上。

4. Brush off the residual powder on the finished surface by paintbrush. 用毛刷清除表面殘留粉末。

Tools: Trowel, Mixing Drill, Plastering Hawk, Sponge or Paintbrush. 工具 | 鏝刀、水泥攪拌機、土帆、西德海綿或毛刷。