Clay Straw Plaster-Base Coat

Only in Melaka Red colour.

Actual colour and texture will be related to actual light. Colour deviations cannot be excluded, each batch of product and aggregate accumulations may cause colour to vary slightly (It’s recommended to order amount required in one purchase). 實際色彩質感與光線有關。無法排除顏色所呈現色差，每一批產品和刷塗堆疊次數都會導致顏色略有差別（建議一次採購所需的量）。

• Natural Mineral Colour / 礦物原色

• Improve Air Quality / 淨化空氣

• Regulate Humidity / 調節濕度

• No Fading Problem / 永不褪色

• Reversible and Reuse / 重複使用

• Low Environmental Impact / 環境友善

Description: It is designed for the base coat to level the very rough uneven cement wall or use to create a thick clay render. Clay Straw Plaster-Base Coat offers better humidity regulation but very low to abrasion resistance, which will cause dusting problem if not coated. For best results, it should be applied on a rough substrate and covered with other Clay Series Plaster product. 描述 | 專為泥土塗料底塗設計，用於抹平非常粗糙不平的水泥牆，或用於打造厚實的塗層；調濕效果非常佳，但耐磨性非常差，若沒有任何其他塗層保護會有掉粉的狀況。為了獲得最佳效果，應將其塗在粗糙的基材上，然後抹上其他泥土系列的泥土塗料產品。

Application: May apply in thick coat and install with fibreglass mesh (if greater than 5 mm) to create a thick clay render to achieve better indoor environment quality. Must be covered with other Clay Series Plaster product. For interior use, do not continue splashed by water. It is always recommended to try it on a small area first! 應用 | 可厚塗，並配合玻璃纖維網（當厚度大於5毫米時）使用，打造厚實的泥土塗層，能創造更佳的室內環境品質。全乾後，務必抹上其他泥土系列的泥土塗料產品。適用室內，水不易持續潑灑處。永遠建議先小面積試做！

Types: Coarse particle sizes (0-1.3mm), matte and rough surface. 款式 | 粗顆粒（0-1.3mm），啞光粗糙面。

Storage: Keep in a dry and cool place. 保存 | 保存於陰涼處。

Installation Steps:

1. Check the subsurface in good condition (rough and clean). 診斷和確保施做基材狀況良好（應夠粗糙且乾淨）。

2. Mix the dry Clay Straw Plaster thoroughly using a mixing drill. Prepare 5 liters of clean water and slowly add the dry mixture into it. Blend at high speed for approximately 10 minutes until the water fully mixes with the ingredients and becomes paste. Let the mixture rest for about 30 minutes, then remix for another 10 minutes before application. 用打泥器將乾粉狀稻草款的原料攪拌均匀。準備5公升清水，將乾粉狀稻草款泥土塗料慢慢倒入。高速攪拌約10分鐘，直到水與原料充分混合，呈糊狀。靜置約30分鐘，使用前再攪拌10分鐘，即可鏝抹。

3. May apply a thick coat by trowel and install with fibreglass mesh if greater than 5 mm. Allow each layer to fully dry before applying the next coat. Before adding the next clay plaster layer, dampen the surface to ensure proper adhesion between layers. 可厚塗，厚度超過 5 毫米時可搭配玻璃纖維網加強。每一層需完全乾燥後再進行下一層施工。在塗抹下一層泥土塗料前，請先將已乾燥的表面潤濕，這樣能確保層與層之間的良好黏附性。

Tools: Trowel, Mixing Drill, Plastering Hawk. 工具 | 鏝刀、水泥攪拌機、土帆。